You will find below the plans to make 3 of the basic wall panels found on Moonbase Alpha.

These measurments are based on observations from promotional slides and also from episodes.

I cannot guaranty that these measurments are 100 % accurate. 

The only measurment I'm totally sure of is the size of the panels themselves which is 8' x 4'. 

But by experience I'm pretty sure they are accurate.

	Trace the black lines on a 1 or 1 1/2 inch thick MDF panel of 8'x4' following the measurments on the left picture. The ones used for Alpha were 1 1/2inch think,(I'm pretty sure) but you might find it harder to cut and to manipulate.  And depending on the size of the room 1 inch can be just enough and will still give you the look.
	Trace 4 inches circles in the specified area as shown in the left picture
	Cut the circle with a 4 inches diameter circular cutter that you attach on a drill.
	Cut along the red lines.
	Final result

2 openings wall panel		5 opennings wall panel		8 openings wall panel

Since November 30th 2005